How CAN KONTROL is organised
CANM8 lists a separate product for each job. CAN KONTROL is organised by function instead: one module family, configured for the function you name. Reverse camera trigger, parking sensor control, road speed feed and lighting outputs each get their own line, so the name tells you what the unit does.
The hardware is the i2CAN platform from Intellitec MV. An i2CAN-4 gives one isolated CAN line running to 1 Mbps, four outputs of up to 900 mA, and a 5V supply for inductive readers. The i2CAN-8 handles two CAN peripherals and eight outputs. CK-CV configurations add J1939 and FMS for commercial vehicles.
What CAN KONTROL includes
- Design and build in the UK. The modules are designed and made in the UK, so a firmware change or a spec question goes to the people who wrote the code.
- Bespoke work. Custom configurations are numbered projects, from a single odd signal to a production run.
- Public guides. Each CAN function has a plain-language guide on this site, linked from the CAN bus hub.
- Support. A UK technical desk handles fitting questions.
Reading the availability column
Every line is programmed for the vehicle it goes into: tell us the make, model, year, the equipment you are feeding and the voltage, and we confirm what the line will do on that vehicle before it ships. That applies in particular to speed and RPM feeds, security lines and commercial vehicle lines.
Switching from CANM8
Switch by function, not by part number. An installer or fleet engineer who knows what the fitted unit does can have the replacement line named in one enquiry.
- Name the function. Write down what the interface has to do on the vehicle: a reverse trigger, a speed feed, a high-beam signal, an ignition-off timer.
- Find the line. Look the CANM8 product name up in the table and note the CAN KONTROL line beside it. If your product is a range name rather than a model, the function column narrows it down.
- Send three details. Vehicle make, model and year; the device being fed; and the voltage, 12V or 24V.
- We confirm and programme. We check the line against that vehicle, set it up, and ship it ready for the job.
- Fit it the way you already fit. Tap CAN high and low with a two-wire connection, or use the no-cut inductive reader. Add a fused permanent supply and an earth.
- Test with LINK. CAN KONTROL LINK is the programming and diagnostic tool, holding every configuration and vehicle file, with remote support.
Fleets can send a list instead of a single vehicle: one row per vehicle type, with the function and the device. Looms are vehicle-specific, so the loom for each type is confirmed in the same reply. When a function has no row in the table, speak to us and an engineer will say whether a standard line or a bespoke build covers it.
Where CAN KONTROL is built
CAN KONTROL is built in Chorley, in the Scorpion Automotive factory that also manufactures CANM8 interfaces. Intellitec MV designed the range and Scorpion Automotive builds it, and the two companies belong to the same group. Scorpion was founded in 1973, and the Chorley factory is IATF 16949 certified.
For a buyer, that means a CAN KONTROL order is a UK build with a UK technical desk behind it. Intellitec MV holds the product pages, datasheets and vehicle lists; this site holds the guides. The interface modules manufacturer page covers how to specify a module.