Speed limiter types compared: which one to choose
The throttle system decides which limiter works, so start there. Five approaches, side by side, with a checklist for vans, trucks and fleets.
Sam P., R&D Technician at Scorpion Automotive. Reviewed by James M., Technical Director at Scorpion Automotive.
Which type of speed limiter should you choose?
Choose by throttle system first. A mechanical limiter suits engines with a fuel-line throttle, drive-by-wire suits electronic throttles, SENT suits the newest trucks, and GPS geofencing adds zone-based limits. The wrong match either does nothing or throws fault codes.
Speak to us about speed limiting
Key facts
- Scorpion Group's Autokontrol makes mechanical, drive-by-wire, SENT and GPS limiters in Chorley
- System 80 is mechanical, works on the fuel line and fits in about 60 minutes
- Drive-by-wire fits in about 1.5 hours and is accurate to +/- 1 km/h
- GeoKontrol 2 sets a different speed for each GPS zone, from 5 to 120 km/h
- The Autokontrol range is type approved to EU/ECE R89, with a 2-year warranty on hardware
Five approaches compared
Figures for the Autokontrol rows come from its published datasheets. The factory row is general, because it varies by maker.
| Approach | How it works | Set speed and accuracy | Fit time | Best for |
|---|---|---|---|---|
| Factory limit | A software limit set by the maker or changed by a dealer | Varies by maker and model | None, or a dealer visit | A single vehicle where the handbook offers a limit and nobody needs to audit it |
| Mechanical (System 80) | Restricts the fuel line, with no electronics | 20 to 120 km/h, +/- 1 to 2 km/h | About 60 minutes | Mechanically controlled engines, harsh sites and older commercial vehicles |
| Drive-by-wire (DBW) | Intercepts the electronic throttle signal | 10 to 130 km/h, +/- 1 km/h | About 1.5 hours | Vans, trucks and buses with electronic throttles, on 12V or 24V |
| SENT | Reads the digital SENT throttle signal of the newest vehicles | 20 to 120 km/h factory set, +/- 1 km/h | 90 to 120 minutes typical | Euro VI trucks from around 2020 that use SENT throttle sensors |
| GPS geofence (GeoKontrol 2) | Sets a speed per GPS zone and updates zones over the air | 5 to 120 km/h per zone | 90 to 120 minutes typical | Depots, sites, airports and 20 mph areas where the limit changes by place |
Tamper protection on the Autokontrol units is a sealed, serial-numbered or sealed-plus-alert design, depending on the model. Check each datasheet at autokontrol.com.
A throttle-first checklist
Work through these in order and stop at the first one that rules a type in or out.
-
Is the throttle a cable or mechanical linkage?
Yes: a mechanical limiter on the fuel line is the match, and it needs no vehicle electronics to work.
-
Is it an electronic pedal on a 2021 or newer truck?
Yes: check whether it uses SENT. A drive-by-wire limiter will not work on a SENT vehicle, so confirm the protocol before ordering.
-
Is it an electronic pedal on a van, older truck or bus?
Yes: drive-by-wire is the likely answer. Ask for the compatible vehicle list for your make and year.
-
Does the allowed speed change by place?
Yes: add GPS geofencing so the vehicle slows itself in depots, schools or 20 mph zones without the driver choosing.
-
Do you also need location and driver reports?
Yes: look at TrackSpeed, which pairs a limiter with AutoM8 tracking in one fitting of about 60 minutes.
-
Is the vehicle leased or sold on soon?
Yes: ask the supplier in writing what removal involves and who does it, before the fitting date is booked.
-
Does your insurer or fleet policy need proof?
Yes: keep the type approval wording and the fitting record, and ask the insurer whether the limiter changes the terms.
Fixed cap or variable limit
A fixed cap holds one top speed everywhere. A variable limiter changes by zone.
- Fixed: simple, cheap to run and easy to explain to drivers. It cannot slow a van down in a depot.
- Variable: adds zones such as 5 mph yards and school hours, at the cost of a connected unit and zone management.
- Combined: a fixed legal cap plus zones is the common pattern for fleets with depot and site work.
The Scorpion Group's speed control specialist, Autokontrol, publishes the full specifications, vehicle lists and quote route for each model. Start at the Autokontrol product range, or see how the same products appear on our speed limiters page.
Rules to check before you buy
Legal duties differ by vehicle class and by country.
- The Autokontrol drive-by-wire datasheet states EU/ECE R89 approval for goods vehicles over 3.5 tonnes and for passenger vehicles with eight or more seats.
- The EU's General Safety Regulation made intelligent speed assistance (ISA) standard on all new vehicles sold from July 2024. ISA assists the driver; it is a different job from holding a hard cap.
- The EU rule does not by itself govern a vehicle registered in Great Britain, so check the position for your market before relying on factory ISA.
- Employers also carry duty-of-care obligations, which our duty of care and speed control page covers.
A limiter is not an excuse to skip a speed policy. Our post on a fleet speed control policy shows what to write down.
Frequently asked questions
What is the difference between a speed limiter and a speed governor?
In everyday use the two words describe the same job: stopping a vehicle exceeding a set top speed. The practical difference is the method, such as a fuel-line restrictor, a throttle-signal interceptor or a GPS zone controller.
Can I fit a drive-by-wire limiter to any modern van?
No. It must match the throttle signal. A drive-by-wire unit expects a PWM or analogue signal, so it will not work on a vehicle that sends SENT, and the vehicle can log fault codes instead.
How accurate is a speed limiter?
Autokontrol publishes plus or minus 1 km/h for its drive-by-wire and SENT limiters and plus or minus 1 to 2 km/h for the mechanical System 80. Real-world results also depend on the vehicle's own speed sensing.
Is a GPS speed limiter the same as a tracker?
No. A GPS limiter uses location to set the maximum speed, while a tracker reports where the vehicle is. TrackSpeed combines a limiter with AutoM8 tracking if you want both from one fitting.
How long does fitting take?
Published times are about 60 minutes for System 80, about 1.5 hours for drive-by-wire and 90 to 120 minutes for SENT and GeoKontrol 2. A trained installer should confirm the time for your vehicle.
Where can I see prices?
Prices are quoted for your vehicles and quantity, so none is printed here. Autokontrol handles quotes for its limiters, and the speed limiters page on this site explains how to start.
Sources
- Autokontrol: speed limiter product range and datasheets (opens in a new tab) (accessed 10 October 2026)
- Regulation (EU) 2019/2144 on type-approval requirements for motor vehicles (EUR-Lex) (opens in a new tab) (accessed 10 October 2026)
Related pages
- Speed limiters The Autokontrol range as shown on Scorpion.
- TrackSpeed A speed limiter and AutoM8 tracking in one fitting.
- Duty of care and speed control What employers owe drivers and the public.
- Speed limiter for cars Limiting a car rather than a commercial vehicle.
- CAN bus speed limiter interface Feeding the vehicle's speed to a limiter.
Not sure which limiter your vehicle takes?
Tell us the make, model, year and throttle type, and we will say which approach fits before you commit to a quote.